Roland u 20 replacement contact strip
Re-attaching it requires special equipment : On the JD, the flex cable is very short and connects to a small pc board mounted under the keybed: The aftertouch sensor also connects to this pcb. You should be brave or a technician. However, if a carbon contact is loose or worn out, you need a replacement strip. Unfortunately, in most cases that is not practical as the amount of time involved in posting that exceeds the value of the 'unique' part. Everything in the internal memory will be erased!
"Synthesizer preservation via restoration and sampling."
I recently purchased a JD which had experienced the dreaded Roland red glue meltdown. The green flex key contact pcb is identical in all three, but the flexes that are heat-sealed to it are different. How easy are they to clean if able.. However, I have found my battery lasting anywhere from 5 to 7 years. That stuff flies everywhere sometimes! Introduction Most of our synth stock is no longer for sale we are using them to design the MIDI programmers , but we still have a wide assortment of vintage synth memory cards , along with parts and keys in stock.
Other - Roland D
Combo-Amp Speaker Cables. It is in excellent working condition. We may "lock up" parts that we may potentially need in the restoration of a unit and not necessarily get it marked 'Hold' or 'Sold' on the site right away. The author is not responsible for any damage or injury resulting from this DIY info. However, if a carbon contacts is loose or worn out, you need a replacement strip. Other complaints are faulty key sensors not triggering notes, slow response times, lackluster Aftertouch response and the dreaded Red Epoxy Syndrome.
Only if we do not have a "viable" unit in yet, either already in process or in line to be processed, that may potentially need parts from a "parts unit", will we release available parts for sale even though they may appear as available for sale to the public. The problem was the error message "NOT GR1" would display but the system would not allow the card to be formatted. Thanks again for your help. One is really lame when it tries to do Aftertouch and the other two initially did not have any Aftertouch at all. However, in a post over at gearsz.